Making User Settings; About User Settings - Pace TDC778X Operator's Manual

Hide thumbs Also See for TDC778X Operator's:

Customer service and installation manual (64 pages)

Table Of Contents

Table of Contents

About User Settings

Your installer should have made the correct settings to make sure your set-top is compatible with

your HDTV or TV. However you may wish to change some settings, for example if you purchase a

new HDTV. You can make the following settings.

• TV Aspect Ratio (the screen's width-to-height ratio, or shape)

• TV Display Capability (screen resolution)

• Auto Pillarbox

• Closed Captions

• Front Panel Settings

You can also reset the user settings to the factory defaults.

You use the L, R, U, D and select buttons on either the front panel or your remote control to make

the settings. You check and change the settings by looking at your set-top's front panel. You can also

look at the on-screen menus, although please note, in some circumstances, these may not be visible.

Putting your set-top into "user settings mode"

1. Make sure that your set-top is turned on.

2. Press the power button on your set-top, then, within 1 second, press the

menu button.

The front panel displays "ASPt" as shown far right. Depending on the set-up, you

may also see the User Settings menu, shown right, on your TV screen.

3. When you have finished making changes (see pages 22 to 30), press the power

button to remove the User Settings menu and return to normal viewing.