NEC Express5800/320Fd-MR N8800-123F, EXP320K User Manual page 355

Finishing the Upgrade
To complete the Active Upgrade process and clean up ftServer system resources after committing or
aborting an upgrade, click Finish on the Commit Upgrade page or Abort Upgrade page.
The finish process should take only a few minutes. When the process completes, the upgrade state is
Fault Tolerant\Idle\Ready.
If the finish process fails the first time, you can click Retry to try again. If the problem persists, see
"Troubleshooting" for information about resolving the problem.
On the Finish page, upon successful completion of the Active Upgrade process, you can:
•
Click Exit to close the Active Upgrade Console.
•
Click Save Log to sage the activity log to a file.
•
Click Active Upgrade in the navigation bar to initiate another readiness test and upgrade with
the same configuration.
•
Click Configuration in the navigation bar to create, edit, or load another configuration file.
IMPORTANT:
Though the Active Upgrade process is complete, your RDR disks continue to resynchronize in
the background. If you intend to initiate another upgrade process, you must wait for the
resynchronization to complete before you do so. See "Verifying If RDR Disks Are
Resynchronizing" on page 5-168 for more information.
TIPS:
Viewing Active Upgrade Process Status, page 5-158
Verifying If RDR Disks Are Resynchronizing, page 5-168
Troubleshooting, page 5-164
Installing and Using Utilities 5-157