NEC Express5800/320Fd-MR N8800-123F, EXP320K User Manual page 145

See the following table for each item.
Item
Runtime BIOS
BBS Support
POST Banner
Display
CTRL-A Message
Display
Physical Drivers
Display During
Post
RAID Support
1. Press F6 to return to the initial value.
2. To quit, press Esc until you see the closing message (If any changes have been made, the
massage asking you whether or not to save the changes is displayed.).
3. When the closing message is displayed, select [Yes] to quit SerialSelect Utility and restart the
system by pressing any key. The changes made in SerialSelect Utility are enabled after the
system is restarted.
Parameter
[Enabled]
Disabled
Disabled:Scan bus
[Device]
Controller
[Enabled]
Disabled
[Enabled]
Disabled
[Enabled]
Disabled
Enabled
[Disabled]
Description
Controls the BIOS status at the POST.
If [Enabled] is selected, the controller can be operated
as a boot device by SAS controller BIOS.
If [Disabled] is selected, other appropriate SAS
controllers operate as boot devices.
If the setting of BBS support is set to [Device], the
boot device connected
registered to the boot menu of system BIOS.
If BBS support is set to [Controller], only SAS
controllers are registered to the BIOS boot menu.
If [Enabled] is selected, Adaptec banner, the version,
and copyright are displayed.
If [Disabled] is selected, Adaptec banner, the version,
and copyright are not displayed.
If [Enabled] is selected, the message "Press
<CTRL><A> for Adaptec SAS/SATA Configuration
Utility!" is displayed in SAS controller BIOS during the
POST. Even if this option is set to [Disabled], the
utility can be started by pressing CTRL+A after the
BIOS title of SAS controllers is displayed.
If [Enabled] is selected, connected physical devices
are displayed during the system POST. However,
depending on the device display, the time that it takes
to complete entire POST can become a few seconds
longer.
Do not set to [Enabled] since RAID is not supported.
System Configuration 4-39
to SAS controllers
[ ]: factory default
is