Table of Contents
Advertisement
Names of Machine Parts and Their Functions
Embroidery Unit
1 Embroidery frame holder
Insert the embroidery frame into the embroidery frame holder
to hold the frame in place. (page B-61)
2 Frame-securing lever
Press the frame-securing lever down to secure the embroidery
frame. (page B-61)
3 Embroidery unit connection
Insert the embroidery unit connection into the connection port
when attaching the embroidery unit. (page B-54)
4 Carriage
The carriage moves the embroidery frame automatically when
embroidering. (page B-54)
5 Release button (located under the embroidery unit)
Press the release button to remove the embroidery unit.
(page B-55)
CAUTION
• Before inserting or removing the embroidery
unit, turn the main power to OFF.
• After the embroidery frame is set in the frame
holder, be sure the frame-securing lever is
correctly lowered.
B-4
Operation buttons
b c
d e f
a
1 "Start/Stop" button
Press the "Start/Stop" button to start or stop sewing. The
machine stitches at a slow speed at the beginning of sewing
while the button is pressed. When sewing is stopped, the
needle is lowered in the fabric. For details, refer to "STARTING
TO SEW" on page B-35.
The button changes color according to the machine's
operation mode.
Green:
The machine is ready to sew or is sewing.
Red:
The machine can not sew.
Orange:
The machine is winding the bobbin thread, or
the bobbin winder shaft is moved to the right
side.
2 Reverse stitch button
For straight, zigzag, and elastic zigzag stitch patterns that use
reverse stitches, the machine will sew reverse stitches at low
speed only while holding down the Reverse stitch button. The
stitches are sewn in the opposite position.
For other stitches, use this button to sew reinforcement
stitches at the beginning and end of sewing. Press and hold
this button, and the machine sews 3 stitches in the same spot
and stops automatically. (page B-39)
3 Reinforcement stitch button
Use this button to sew a single stitch repeatedly and tie-off.
For character/decorative stitches, press this button to end with
a full stitch instead of at a mid-point. The LED light beside this
button lights up while the machine is sewing a full motif, and
automatically turns off when the sewing is stopped. (page B-
38)
4 Needle position button
Press the needle position button to raise or lower the needle.
Pressing the button twice sews one stitch.
5 Thread cutter button
Press the thread cutter button after sewing is stopped to cut
both the upper and the bobbin threads. For details, refer to
l
step
under the "Sewing a stitch" section on page B-36.
6 Presser foot lifter button
Press this button to lower the presser foot and apply pressure
to the fabric. Press this button again to raise the presser foot.
7 Sewing speed controller
Slide the sewing speed controller to adjust the sewing speed.
CAUTION
• Do not press
(Thread cutter button) after
the threads have already been cut, otherwise
the needle may break, the threads may
become tangled or damage to the machine
may occur.
g
Advertisement
Table of Contents
Troubleshooting
