Table of Contents
Advertisement
Reinforcement Stitching
• When lowering the presser foot, do not push in the
front of the presser foot, otherwise the bar tack will
not be sewn with the correct size.
1 Do not reduce the gap.
e
Pull down the buttonhole lever as far as possible.
a
1 Buttonhole lever
The buttonhole lever is positioned behind the bracket
on the buttonhole foot.
1
2
1 Buttonhole lever
2 Bracket
f
Gently hold the end of the upper thread in your left
hand, and then start sewing.
g
Raise the presser foot lever, remove the fabric, and
then cut the threads.
h
Raise the buttonhole lever to its original position.
Memo
• If the fabric does not feed, for example, because it
is too thick, increase the stitch length. For details,
refer to "Setting the stitch length" in the "Basic
operations" section.
S-36
a
a
b
c
Darning
1 Reinforcement stitching
Determine the desired length of the darning.
Set the button guide plate on buttonhole foot "A" to the
desired length. (The distance between the markings on
the presser foot scale is 5 mm (3/16 inch).)
2
4
1 Presser foot scale
2 Length of darning
3 5 mm (3/16 inch)
4 7 mm (1/4 inch)
• A bar tack with a maximum length of about 28 mm
(1-1/8 inches) can be sewn.
→ Once sewing is completed, the machine
automatically sews reinforcement stitches, then
stops.
Attach buttonhole foot "A".
Select stitch
or
.
1
3
Advertisement
Table of Contents
Troubleshooting
