Table of Contents
Advertisement
Editing All Patterns
e
Use
to align the needle and the mark on the
fabric, and begin embroidering the pattern.
Embroidering linked characters
Follow the procedure described below to embroider linked
characters in a single row when the entire pattern extends
beyond the embroidery frame.
Example: Linking "DEF" to the characters "ABC" using
embroidery frame 10 cm × 10 cm (4 inches × 4 inches)
(sold separately with some models)
a
Select the character patterns for "ABC", and then press
and
.
Note
• For details on selecting character patterns, refer
to "Selecting character patterns" on page E-2.
b
Press
.
c
Press
, and then press
→ The needle is positioned in the lower-left corner of
the pattern. The embroidery frame moves so that the
needle is positioned correctly.
E-16
.
Note
• To cancel the starting point setting and return
the starting point to the center of the pattern,
press
.
• Use
to select a different starting point for
embroidering.
d
Press
.
e
Lower the embroidery foot and then press the
"Start/Stop" button to begin embroidering.
f
After the characters are embroidered, cut the threads,
remove the embroidery frame, and then press
"Finished embroidering".
1 End of the embroidering
g
Reposition the fabric in embroidery frame so that the
right side of the letter "C" will be partially inside the
embroidery frame; being careful so letters remain
straight and level. Then reattach frame again so that
the remaining characters ("DEF") can be embroidered.
h
Press
and then press
for
.
Advertisement
Table of Contents
Troubleshooting
