Table of Contents
Advertisement
Troubleshooting
Error messages
Selected pattern field extends to the outside of the
embroidery frame.
18
The bobbin thread is almost empty.
19
The bobbin winder safety device has activated. Is
20
the thread tangled?
The carriage of the embroidery unit will
21
move. Keep your hands etc. away from the
carriage.
The pockets are full. Delete a pattern.
22
The safety device has been activated. Is the
23
thread tangled? Is the needle bent?
The "Start/Stop" button does not operate with the
24
foot controller attached. Remove the foot controller.
The USB media was changed. Do not change the
25
USB media while it is being read.
There is a pattern included that cannot be saved to
26
USB media. Save the pattern in the machine's
memory.
This pattern cannot be sewn with this mode.
27
This pattern cannot be used.
28
29
This USB media cannot be used.
Turn off the power and replace the needle
30
plate.
31
USB media error
USB media is not loaded. Load USB media.
32
When the speed controller is set to control the
zigzag stitch width, the "Start/Stop" button does
33
not operate.
F**
34
A-20
Cause/solution
This message appears when the selected embroidery pattern is larger than
the extra large embroidery frame. Reduce the pattern size, or select a
different pattern.
This message appears when the selected embroidery pattern is larger than
the embroidery frame selected when "Embroidery Frame Identification View"
is set to "ON".
This message is displayed when the bobbin thread is running out. Follow the
procedure described in "If the bobbin runs out of thread" on page E-23.
This message is displayed when the bobbin is being wound, and the motor
locks because the thread is tangled, etc.
This message appears before embroidery unit moves.
This message is displayed when the memory is full and a pattern must be
deleted.
This message is displayed when the motor locks due to tangled thread or for
other reasons related to thread delivery.
This message is displayed when the "Start/Stop" button is pressed to sew
Utility stitches or Character/Decorative stitches while the foot controller is
connected.
This message is displayed when you attempt to select a pattern after the
USB flash drive in which the pattern is saved has been changed.
Depending on the pattern, it may not be possible to save it to a USB flash
drive.
This message is displayed when the selected stitch is not available for the
specific function.
This message appears when you try to retrieve a pattern that cannot be used
with this machine.
This message is displayed when you try to use incompatible media.
This message is displayed when you try to sew with a stitch other than a
straight stitch (middle needle position) while the straight stitch needle plate is
installed.
This message is also displayed when the needle plate is removed while the
machine is still turned on.
This message is displayed when an error occurs with the USB flash drive.
This message is displayed when you try to recall or save a pattern while no
USB flash drive is loaded.
This message is displayed when the speed control lever is set to control the
zigzag stitch width, and the "Start/Stop" button is pressed. Set "Width
Control" to "OFF" in the settings screen (page B-13), or use the foot
controller to operate the machine.
If error message "F**" appears in the LCD while the sewing machine is being
used, the machine may be malfunctioning. Contact your authorized Baby
Lock retailer.
Advertisement
Table of Contents
Troubleshooting
