Table of Contents
Advertisement
Winding/Installing the Bobbin
Winding/Installing the Bobbin
CAUTION
• Only use the Bobbin (part code: X52800-120)
designed specifically for this machine. Use of
any other bobbin may result in injuries or
damage to the machine.
• The included bobbin was designed specifically
for this machine.
If bobbins from other models are used, the
machine will not operate correctly. Use only
the included bobbin or bobbins of the same
type (X52800-120).
X52800-120 is Class15 type bobbin.
*
Actual size
1 This model
2 Other models
3 11.5 mm (approx. 7/16 inch)
Memo
• When the foot controller is connected, bobbin
winding can be started and stopped with the foot
controller.
Winding the bobbin
This section describes how to wind thread onto a bobbin.
Memo
• When winding bobbin for embroidery be sure to
use the recommended bobbin thread for this
machine.
B-18
a
Open the top cover.
b
Place the bobbin on the bobbin winder shaft so that the
spring on the shaft fits into the notch in the bobbin
Press down on the bobbin until it snaps into place.
1 Notch
2 Bobbin winder shaft spring
c
Slide the bobbin winder in the direction of the arrow
until it snaps into place.
• The "Start/Stop" button lights up in orange.
d
Remove the spool cap that is inserted onto the spool
pin.
2
1 Spool pin
2 Spool cap
.
1
2
1
Advertisement
Table of Contents
Troubleshooting
