Attaching The Continuous Border Hoop To The Embroidery Unit - Baby Lock Ellisimo BLSO-BF Instruction And Reference Manual

e
Place the embroidery sheet in the upper
frame, align the guide line on the embroidery
sheet with the mark (line) on the fabric, and
then press down on the left and right locking
levers until they click into place.
a Locking levers
Memo
• The fabric can also be positioned in the continuous
border hoop by aligning the edge of the fabric with
the inner markings on the upper frame.
Note
• If there is excess fabric after the center of the
embroidering area is aligned with the center of the
continuous border hoop, fold over the excess fabric,
place it on top of the upper frame, and then press
down on the levers. Be careful that the folded
excess fabric is not caught in the embroidering area.
f
Remove the embroidery sheet, and then pull
the four sides of the fabric to remove any
slack. Finally, check that the fabric is firmly
stretched.
6
■ Attaching the Continuous Border Hoop to
the Embroidery Unit
CAUTION
• After firmly hooping the fabric in the continuous
border hoop, attach the frame to the embroidery
unit. Otherwise, the needle may break and cause
injuries.
• Before attaching the continuous border hoop to the
embroidery unit, make sure that the needle and
presser foot have been raised. Otherwise, the
needle may break and cause injuries.
Note
• Before attaching the continuous border hoop, wind
the bobbin with thread and install it.
a
Make sure that the needle and presser foot
have been raised. If the needle has not been
raised, press the "Needle Position" button to
raise it. If the presser foot has not been raised,
press the "Presser Foot Lifter" button to raise
it.
b
Make sure that the embroidery unit carriage
has moved to its initial position.
c
Align the guide on the continuous border
hoop with the right edge of the embroidery
frame holder.
b
a
Embroidery frame holder
b
Guide on continuous border hoop
a