Show Ip Brief; Show Ip Interface - Planet Networking & Communication WGS3-24000 User Manual

12.2.19 encapsulation
This command configures the link layer encapsulation type for the packet. The encapsulation type can be ethernet or snap.
▫
Default ethernet
▫
Format encapsulation {ethernet | snap}
▫
Mode Interface Config
Note : Routed frames are always ethernet encapsulated when a frame is routed to a VLAN.

12.2.20 show ip brief

This command displays all the summary information of the IP.
▫
Format show ip brief
▫
Modes Privileged EXEC
User EXEC
▫
Default Time to Live
The computed TTL (Time to Live) of forwarding a packet from the local router to the final destination.
Shows whether the routing mode is enabled or disabled.
Routing Mode
IP Forwarding Mode Shows whether forwarding of IP frames is enabled or disabled. This is a configured value.
Maximum Next Hops Shows the maximum number of next hops the packet can travel.

12.2.21 show ip interface

This command displays all pertinent information about the IP interface.
Format show ip interface <slot/port>
Modes Privileged EXEC
User EXEC
Primary IP Address
Secondary IP Address
Routing Mode
Administrative Mode
Displays the primary IP address and subnet masks for the interface.
This value appears only if you configure it.
Displays one or more secondary IP addresses and subnet masks for the interface.
This value appears only if you configure it.
Is the administrative mode of router interface participation.
The possible values are enable or disable. This value was configured into the unit.
Is the administrative mode of the specified interface. The possible values of this field are
436