Table of Contents
Advertisement
Preference
12.4 Virtual LAN Routing Commands
This section describes the commands you use to view and configure VLAN routing and to view VLAN routing status information.
12.4.1 vlan routing
This command creates routing on a VLAN. The <vlanid> value has a range from 1 to 4094.
Format
vlan routing <vlanid>
Mode
VLAN Config
12.4.1.1 no vlan routing
This command deletes routing on a VLAN. The <vlanid> value has a range from 1 to 4094.
Format
no vlan routing <vlanid>
Mode
VLAN Config
12.4.2 show ip vlan
This command displays the VLAN routing information for all VLANs with routing enabled.
Format
show ip vlan
Modes
Privileged EXEC
User EXEC
MAC Address used by
Routing VLANs
VLAN ID
Logical Interface
IP Address
Subnet Mask
12.5 Virtual Router Redundancy Protocol Commands
This section describes the commands you use to view and configure Virtual Router Redundancy Protocol (VRRP) and to view
VRRP status information. VRRP helps provide failover and load balancing when you configure two devices as a VRRP pair.
Displays the preference of the address as a default router address, relative to other router
addresses on the same subnet.
Is the MAC Address associated with the internal-bridge-router interface (IBRI). The same
MAC Address is used by all VLAN routing interfaces. It will be displayed above the
per-VLAN information.
Is the identifier of the VLAN.
Shows the logical slot/port associated with the VLAN routing interface.
Displays the IP Address associated with this VLAN.
Indicates the subnet mask that is associated with this VLAN
443
Advertisement
Table of Contents
