Connector Pin-Outs; Mounting The Cradle - Motorola MC67 Integrator Manual

• in-line fuse holder (included), must be used if not connecting to vehicle's fuse panel

Connector Pin-Outs

Figure 26: VCD5500 Power Connection
1
Table 5: Power Input Cable
Pin
1
2
3
4
Caution: ROAD SAFETY - Do not use the MC67 while driving. Park the vehicle first. Always ensure the
MC67 is fully inserted into the cradle. Do not place it on the seat or where it can break loose in a collision
or sudden stop. Lack of proper insertion may result in property damage or personal injury. Zebra is not
responsible for any loss resulting from the use of the products while driving. Remember: Safety comes
first.

Mounting the Cradle

Caution: Only mount the Vehicle Cradle in a vertical position with the release level at the top or in a
horizontal position with the MC67 display facing up. Never mount the vehicle cradle on the side or upside
down or on a wall that can be subject to impact or collision of greater than 40Gs, in accordance with SAE
J1455 Section 4.10.3.5
Procedure:
1 Select a mounting location for the cradle. It should be flat, and must provide adequate support for the cradle.
Note: If using the GPS functionality of the MC67, ensure that the vehicle cradle is positioned so that
the MC67 has a clear unobstructed view of the sky.
2 Prepare the mounting surface to accept four #8-32 studs, using the mounting template below. Drill four holes with
a #6 drill bit.
Figure 27: Vehicle Cradle Mounting Template
1.2"
Signal
Chassis ground (Black Wire)
Chassis ground (Bare Wire)
V+ (Red Wire)
V+ (Red Wire)
1.5"
Accessories | 39
MN000116A02-A | May 2015