Configuring Ethernet Static Ip Address - Motorola MC67 Integrator Manual

34 | Accessories
11 Note: When entering proxy addresses in the Bypass proxy for field, do not use spaces or carriage
returns between addresses.
In the Bypass proxy for text box, enter addresses for web sites that do not require to go through the proxy server.
Use the separator "|" between addresses.
12 Touch Modify.
13 Touch
.

Configuring Ethernet Static IP Address

The MC67 includes Ethernet cradle drivers. After inserting the MC67, configure the Ethernet connection:
Procedure:
1
Touch .
2
Touch .
3 Touch Ethernet.
4 Slide the switch to the ON position.
5 Place the MC67 into the Ethernet cradle slot.
6 Touch and hold Eth0 until the menu appears.
7 Touch Disconnect.
Figure 20: Ethernet Proxy Settings
8 Touch and hold Eth0 until the menu appears.
9 Touch the IP setting drop-down list and select Static.
10 In the IP adress field, enter the proxy server address.
11 If required, in the Gateway text box, enter a gateway address for the device.
12 If required, in the Network prefix length text box, enter a the prefix length.
13 If required, in the DNS 1 text box, enter a Domain Name System (DNS) address.
14 If required, in the DNS 2 text box, enter a DNS address.
15 Touch Connect.
May 2015 | MN000116A02-A