Time Settings - Interlogix TVE-110 User Manual

Save Clips To: Set the saving path for the clipped video files in playback
mode.
Save Downloaded Files To: Set the saving path for the downloaded video
files or pictures.
3. Click Save to save the settings.

Time settings

You can set the date and time that will appear on-screen and on time stamped
recordings. The start and end times of daylight savings time (DST) in the year
can also be set.
A Network Time Protocol (NTP) server can also be set up on your encoder to
keep the date and time current and accurate. If the encoder is connected to a
Dynamic Host Configuration Protocol (DHCP) network that has time server
properties configured, the cameras will synchronize automatically with the time
server.
To configure time settings:
1. Click Configuration
Settings. The Time Settings window appears.
2. Select the time zone.
Select the time zone that is closest to the device's location from the drop-
down list.
3. Configure the time synchronization method: NTP server or manually.
Configuring time sync by NTP server: Check the
address and port of the NTP server.
Note: If the encoder is connected to a public network, you should use a NTP
server that has a time synchronization function, such as the server at the
National Time Center (IP Address: 210.72.145.44) or europe.ntp.pool.org. If
16
> Remote Configuration
TVE-110/410/810/1610 H.264 IP Video Encoder User Manual
> Device Parameters
NTP box. Enter the IP
> Time