Using The T2000 Diagnostic Program - Toshiba T2000 Maintenance Manual

3.2 Using the T2000 Diagnostic Program

To start the T2000 Diagnostic Program, follow these steps:
1. Make sure the computer is loaded with Toshiba MS-DOS version 3.3 or 4.0. Turn on the
T2000 and insert the T2000 Diagnostics Diskette in the floppy disk drive.
2. Change to the A drive. Then type A:TESTCE2 and press Enter.
3. The DIAGNOSTICS MENU will be displayed as shown below.
TOSHIBA personal computer T2000 DIAGNOSTICS
version x.xx (c) copyright TOSHIBA Corp. 1991
DIAGNOSTICS MENU :
1 - DIAGNOSTIC TEST
2 - HARD DISK FORMAT
3 -
4 - HEAD CLEANING
5 - LOG UTILITIES
6 - RUNNING
7 - FDD UTILITIES
8 - SYSTEM CONFIGURATION
9 - EXIT TO MS-DOS
0 - SETUP
PRESS [0] - [9] KEY
NOTE: To exit the Diagnostic Test function, press Ctrl + C. If a test is in progress,
press Ctrl + Break to exit the test.
3-6
TEST