Toshiba T2000 Maintenance Manual page 30

Check system. Then press [F1] key.
If another error message appears, refer to Check 3.
Check 3 If the following message appears, and the status of the printer port LED is F4h to
F6h, replace the system board. Otherwise, press any key. At this time the resumed
data will be erased.
WARNING: RESUME FAILURE.
PRESS ANY KEY TO CONTINUE.
WARNING:
YOU MUST FORMAT HARD RAM BEFORE USE
PRESS ANY KEY TO CONTINUE
If another error message appears, refer to Check 4.
Check 4 The IRT program tests the system board. If an error occurs in the IRT program, the
error message appears on the screen and beep sounds are generated.
If the following message appears, replace the system board. Otherwise, refer to
Check 5.
ERROR INTERRUPT CONTROLLER #1
ERROR INTERRUPT CONTROLLER #2
MEMORY VERIFY ERROR AT xxxx:xxxx FOUND xxxx
EXPECTED xxxx
ERROR INTERRUPTS AND STUCK NMI
ERROR PROTECT MODE
ERROR PROCESSOR EXCEPTIONAL INTERRUPTS
Check 5 If the following message is displayed on the screen, refer to the Hard Disk Drive
Problem Isolation Procedures in Section 2.6.
If the following error message does not appear and the beep sounds do not occur,
refer to Procedure 2.
2-16
DATA IN HARD RAM WAS LOST