Completing The Move; Fitting The Stability Bracket Or Chain; Repositioning The Cooker Following Connection - Rangemaster Arleston 110 Dual Fuel User's Manual & Installation Instructions

Check the appliance is electrically safe and gas sound when you have finished.
Fig.7.5
Fig.7.6
ArtNo.010-0004 Moving the cooker
Fig.7.7
Stability chain
Stability bracket
Fig.7.8
3 mm min
ArtNo.070-0014 - Stability bracket - Wall fitting
Typical oor mounting
Fig.7.9 Outer stability
bracket
3 mm min
Wall
Typical wall mounting
INSTALLATION
Lowering the Two Rear Rollers
To adjust the height of the rear of the cooker, first fit a 13 mm
spanner or socket wrench onto the hexagonal adjusting
nut (Fig.7.5). Rotate the nut – clockwise to raise – counter-
clockwise to lower.
Make 10 complete (360°) turns clockwise.
Make sure you lower BOTH REAR ROLLERS.

Completing the Move

Unfold the rear edge of the cardboard base tray. Open the
grill door and right-hand oven door so that you can get a
good grip on the bottom of the fascia panel as you move the
oven (Fig.7.6).
Carefully push the cooker backwards off the cardboard base.
Remove the base tray.
Position the cooker close to its final position, leaving just
enough space to get behind it.
n

Fitting the Stability Bracket or Chain

Unless otherwise stated, a cooker using a flexible gas
connector must be secured with a suitable stability device.
Suitable stability devices are shown in Fig.7.7, Fig.7.8 and
Fig.7.9.
If you are using a stability chain (Fig.7.7) then the chain
should be kept as short as is practicable and fixed firmly to
the rear of the cooker.
If you are using a stability bracket (Fig.7.8 and Fig.7.9.), then
adjust the bracket to give the smallest practicable clearance
between the bracket and the engagement slot in the rear of
the cooker.
Fit the bracket so that it engages as far as possible over the
chassis of the cooker.
Cooker
Repositioning the Cooker Following
Connection
If you need to move the cooker once it has been connected
Floor
then you need to unplug it and, having gripped under the
fascia panel and lifted the front of the cooker slightly
(Fig.7.6), you need to check behind the cooker to make sure
that the gas hose is not caught.
As you progress, make sure that both the electricity cable and
gas hose always have sufficient slack to allow the cooker to
move.
Cooker
With a stability chain fitted, release it as you ease the cooker out.
Do not forget to refit it when you replace the cooker.
When you replace the cooker, again check behind to make
sure that the electricity cable and gas hose are not caught or
trapped.
Floor
22
DO NOT use the door handles or control knobs to
n
manoeuvre the cooker.