Table of Contents
Advertisement
Check the appliance is electrically safe and gas sound when you have finished.
Fig. 9.5
Fig. 9.6
Fig. 9.7
Stability chain
Fig. 9.8
Alternative positions
for stability location
bracket
Stability bracket
Fig. 9.9
Stability
location
bracket
ArtNo.070-0014 - Stability bracket - Wall fitting
Typical oor mounting
Stability
Fig. 9.10
bracket
Stability
location
bracket
Wall
ArtNo.070-0014 - Stability bracket - Wall fitting
Typical wall mounting
INSTALLATION
Lowering the Two Rear Rollers
To adjust the height of the rear of the cooker, first fit a 13 mm
spanner or socket wrench onto the hexagonal adjusting
nut (Fig. 9.5). Rotate the nut – clockwise to raise – counter-
clockwise to lower.
Make 10 complete (360°) turns clockwise.
Make sure you lower BOTH REAR ROLLERS.
Completing the Move
Unfold the rear edge of the cardboard base tray. Open the
grill door and right-hand oven door so that you can get a
good grip on the bottom of the fascia panel as you move the
oven (Fig. 9.6).
Carefully push the cooker backwards off the cardboard base.
Remove the base tray.
Position the cooker close to its final position, leaving just
enough space to get behind it.
n
Fitting the Stability Bracket or
Chain
Unless otherwise stated, a cooker using a flexible gas
connector must be secured with a suitable stability device.
Suitable stability devices are shown in Fig. 9.7, Fig. 9.8,
Fig. 9.9 and Fig. 9.10.
If you are using a stability chain (Fig. 9.7) then the chain
should be kept as short as is practicable and fixed firmly to
the rear of the cooker.
If you are using a stability bracket; first attach the bracket
location device to the rear of the cooker (Fig. 9.8). Then
adjust the bracket to engage through the slot of the device
(Fig. 9.9 and Fig. 9.10).
Repositioning the Cooker
Following Connection
Cooker
If you need to move the cooker once it has been connected
then you need to unplug it and, having gripped under the
fascia panel and lifted the front of the cooker slightly
(Fig. 9.6), you need to check behind the cooker to make sure
Floor
that the gas hose is not caught.
As you progress, make sure that both the electricity cable and
gas hose always have sufficient slack to allow the cooker to
move.
Cooker
With a stability chain fitted, release it as you ease the cooker
out. Do not forget to refit it when you replace the cooker.
When you replace the cooker, again check behind to make
sure that the electricity cable and gas hose are not caught or
Floor
trapped.
26
Do not use the door handles or control knobs to
n
manoeuvre the cooker.
Advertisement
Table of Contents
