Symbol MC9000-K/S Reference Manual page 603

Hide thumbs Also See for MC9000-K/S:
Table of Contents

Advertisement

• Pointer Timer is not supported.
• Image Capture Timeout is not supported.
• Image Compress Timeout is not supported.
• Linear Sec sets the number of times a bar code is re-read to confirm an accurate decode.
Tap to toggle between Short, Redun (two times redundancy based on redundancy flags
and code length); Short, Codabar (two times redundancy if short bar code or CODABAR);
All codes *2 (two times redundancy for all bar codes); Long *2 Short *3 (two times
redundancy for long bar codes, three times for short bar codes); and, All codes *3 (three
times redundancy for all bar codes).
• Focus Mode sets the focus mode to use. Fixed mode is currently the only focus mode
supported.
• Focus Position sets the fixed focus position to use. Tap to toggle between Far (focus
position is 9 inches) and Near (focus position is 5 inches).
Laser Scanner Parameters
• Reader Type displays the type of bar code reader used (Imager type scan engine or laser
type scan engine).
• Aim Type sets the type of aiming to use. Tap to toggle between Timed Release (activation
stops even if the trigger is still held after a specified period of time); Timed Hold (trigger
can be released but it remains active for the specified period of time); and, Trigger (on/
off controlled by the trigger).
• Aim Duration sets the duration in milliseconds (0-60,000 in increments of 100) for timed
aim modes. Tap to select the duration.
• Aim Mode sets the aiming mode to use. Only None (no aiming), Slab (slab aiming) and
Dot (dot aiming) are supported.
• Beam Width sets the laser beam width. Tap to toggle between Normal and Narrow.
• Raster Mode is not supported.
• Beam Timer sets the maximum amount of time that the laser remains on (0-60,000 in
increments of 100). A value of 0 means infinite time-out.
• Control LED is not supported.
• LED Level is not supported.
• Class 1 Sup is not supported.
• Redundancy sets the read direction for the bar code redundancy. Tap to toggle between
None and Bidirectional (reads in both directions).
B-29

Advertisement

Table of Contents
loading

Table of Contents