Disassembly Of The Cooling Compartment Insulation - Douwe Egberts Cafitesse 100 Service Manual

Service Manual Cafitesse 100
F.2.2 Disassembly of the Cooling
Compartment Insulation
Preparation:
• Disconnect the dispenser from the mains
supply and close the water tap.
• Remove the front cover.
CAUTION: When the front cover is made
of glass, there is the danger of
being injured if the glass cover
breaks.
• Completely remove the front part.
(see chap. G.5)
• Withdraw the sheet covering (1) from the
cooling compartment insulation and unplug
the cable harness (2) from the pc board.
(Fig. 1)
Disassembly:
• Remove the cooling compartment top (3).
(Fig. 1)
• Remove the B2 coil:
- remove the cellular sealing (4). (Fig. 1)
- loosen the screws (5) and withdraw the B2
coil. (Fig. 1)
• Remove the bottom part (6) and the upper
part (7) of the cooling compartment
insulation and cut it up if required. (Fig. 1)
CAUTION: The Peltier element must not
be damaged.
Observe that the cooling
compartment is not placed on
top of the Peltier element.
Do not dismount the Peltier
element.
• Insert the new cooling compartment
insulation (8) in the following order. (Fig. 2)
• Place the cable (9) in the recess of the
upper cooling compartment insulation part.
(Fig. 2)
CAUTION: Observe that the Peltier
element cables are placed
correctly.
• First, insert the upper part (10) of the new
insulation and then the bottom part (11).
(Fig. 2)
5F - 2
Functions - Cooling System
2
xx
xx
x
x x
x x
x
S T
O P
Fig. 1
1 5
10
8
11
Fig. 2
3
7
6
4
9
07.2004