Vertical rooftop installation
Fitting the connecting chamber
Turn T-slot bolts 90° for all installation steps.
1. Position the connecting chamber
onto the mounting rails and click it
into the retaining plates.
2. Align the connecting chambers.
Note
The tube holders on the mounting
rails must be in line with those in
the connecting chambers; where
necessary, align with a piece of
string.
30
(cont.)
3. Tighten the mounting rails with the
clamping brackets.
4. Where several collectors are
installed side-by-side, continue
with "Installing the connecting
chamber" on page 45, otherwise
continue with "Fitting the vacuum
tubes" on page 46.