Water connections
2. Push the tubes into the tube
holders until they click and push
them into the header as far as pos-
sible.
The tubes will lock into the locking
spring.
Removing tubes
If a tube must be removed, proceed
as follows:
1. Remove the rubber seal from the
groove of the casing cover and
open the casing.
(cont.)
3. For south-facing roofs, adjust the
angle of inclination of the absorber
with the enclosed template.
The coated side of the absorber
should be turned towards the sun.
4. Secure the tubes with the retaining
rubber.
2. Push the locking spring upwards
out of the tube holders on the
header.
3. Carefully remove the tubes.
47