Fitting Collector Supports, Adjusting Angle Of Inclination; Installation On Substructure, E.g. Steel Beams - Viessmann Vitosol-F Installation Instructions Manual

Installation on collector supports

Fitting collector supports, adjusting angle of inclination

1.
Fig. 6 For angles of inclination, see Fig. 2 and 4.

Installation on substructure, e.g. steel beams

Installation information:
Observe the maximum load and distance from the
■
edge of the roof for the on-site substructure to DIN
1055.
■ Install the on-site substructure at right angles to and
horizontally level with the collector orientation.
(cont.)
6 5
2.
6
5
7
α
7
Secure joining plate
■
between the second and third supports, the fourth
and fifth, etc.
■ For each of the 1 to 6 collectors installed side by
side, secure 2 cross braces diagonally to the adjust-
able supports using screws (see following diagram).
to the retaining plates
qP
9