Installation - Viessmann VITOSOL 200 Installation Instructions Manual

Water connections
3. Fit the tee onto the flow connec-
tor.
4. Insert the sensor well into the tee,
holding the tee tightly.
5. Insert the strain relief fitting into
the sensor well.
6. Insert the collector temperature
sensor as far as possible into the
sensor well and secure with PG
thread.
7. Insert the U-pipe as far as possi-
ble, then secure with profile clips.

Installation

!
Please note
Incorrect installation can lead to collector damage.
Use only gunmetal and brass fittings and copper pipes for the installa-
tion.
Use hemp only in conjunction with pressure and temperature-resistant
sealants (e.g. Viscotex Solarpaste from Locher, CH-9450 Altstätten).
Never step onto solar panels.
Never solder near or on the collector.
(cont.)
8. Insert the support sleeves into the
pipework of the solar circuit.
Make the connection between the
collector array and pipework of
the solar heating circuit.
9. Check the system pressure and
test for leaks.
10. Fit the thermal insulation and join
its cut faces with adhesive.
11. Fit and secure the thermal insula-
tion cap.
"Vitosol" service instruc-
tions.
51