Config Bandwidth_Control; Show Bandwidth_Control - D-Link DES-1210-28/ME Reference Manual

config bandwidth_control

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure bandwidth control configuration:
DES-1210-28/ME:5# config bandwidth_control all rx_rate no_limit tx_rate
no_limit
Command: config bandwidth_control all rx_rate no_limit tx_rate no_limit
Success
DES-1210-28/ME:5#

show bandwidth_control

Purpose
Syntax
Description
Parameters
Restrictions
DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
-------- ----------
Class-0 strict
Class-1 strict
Class-2 strict
Class-3 strict
DES-1210-28/ME:5#
To configure bandwidth control on the Switch.
config bandwidth control [<portlist> | all] {rx_rate [no_limit |
<value 64-1024000>] | tx_rate [no_limit | <value 64-1024000>]}
The config bandwidth_control command defines bandwidth
control.
portlist - A port or range of ports to be configured.
all - Specifies that the config bandwidth_control command applies
to all ports on the Switch.
rx_rate - Enables ingress rate limiting
no_limit – Indicates no limit is defined.
•
<value 64–1024000>] – Indicates a range between 64-
•
1024000 kbps.
tx_rate – Enables egress rate limiting.
no_limit – Indicates no limit is defined.
•
<value 64-1000000>] – Indicates a range between 64-
•
1024000 kbps.
Only administrator or operator-level users can issue this command.
To display bandwidth control settings on the Switch.
show bandwidth control [<portlist> | all]
The show bandwidth_control command displays bandwidth
control.
<portlist> – A port or range of ports to be configured.
all – Specifies that the show bandwidth_control command applies
to all ports on the Switch.
None.
132