Config 802.1X Init - D-Link DES-1210-28/ME Reference Manual

Restrictions
Example usage:
To configure 802.1x authentication parameters for ports 1 – 20:
DES-1210-28/ME:5# config 802.1x auth_parameter ports 1-5 direction both
Command: config 802.1x auth_parameter ports 1-5 direction both
Success!
DES-1210-28/ME:5#

config 802.1x init

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To initialize the authentication state machine of all ports:
DES-1210-28/ME:5# config 802.1x init port_based ports all
Command: config 802.1x init port_based ports all
Success.
DES-1210-28/ME:5#
DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
max_req <value 1-10> – Configures the number of times to retry
sending packets to a supplicant (user).
reauth_period <sec 300-4294967295> – Configures the time interval
between successive re-authentications.
enable_reauth [enable | disable] – Determines whether or not the
Switch will re-authenticate. Enabled causes re-authentication of
users at the time interval specified in the Re-authentication Period
field, above.
direction [both | in] –Sets the administrative-controlled direction to
Both. If Both is selected, control is exerted over both incoming and
outgoing traffic through the controlled port selected in the first field.
The In option is not supported in the present firmware release.
Only Administrator or operator-level users can issue this command.
To initialize the 802.1x function on a range of ports.
config 802.1x init port_based ports [<portlist> | all]
The config 802.1x init command initializes the 802.1x functions on
a specified range of ports or for specified MAC addresses operating
from a specified range of ports.
port_based – Instructs the Switch to initialize 802.1x functions based
only on the port number. Ports approved for initialization can then be
specified.
ports <portlist> – A port or range of ports to be configured.
all – Specifies all of the ports on the Switch.
Only Administrator or operator-level users can issue this command.
217