D-Link DES-1210-28/ME Reference Manual page 294

Parameters
Restrictions
Example usage:
To configure LLDP TLV PVID:
DES-1210-28/ME:5# config lldp ports all dot1_tlv_pvid disable
Command: config lldp ports all dot1_tlv_pvid disable
Success!
DES-1210-28/ME:5#
config lldp ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure LLDP ports configuration status:
DES-1210-28/ME:5# config lldp ports all dot1_tlv_protocol_identity eapol enable
Command: config lldp ports all dot1_tlv_protocol_identity eapol enable
Success!
DES-1210-28/ME:5#
config lldp ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure LLDP mac_phy_configuration status:
DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
[<portlist> | all] – Specify a port or ports to be configured.
[enable | disable] - Defines if the advertisement is enabled or disabled.
Only Administrator or operator-level users can issue this command.
To define LLDP management basic TLVs advertisement on a port or ports.
config lldp ports ports [<portlist>|all] dot1_tlv_protocol_identity [all |
eapol | gvrp | lacp | stp][disable | enable]
The config lldp ports dot1 TLVs command defines if lldp will advertise the
mac_phy_configuration_status the command is per port on the switch.
[<portlist> | all] – Specify a port or ports to be configured.
dot1_tlv_protocol_identity − Defines if the advertisement is enabled or
disabled. The possible values are: eapol, gvrp, lacp, stp or all.
Only Administrator or operator-level users can issue this command.
To define LLDP management basic TLVs advertisement on a port or ports.
config lldp ports ports [<portlist>|all] dot1_tlv_vlan_name [vlan
<vlan_name 32> | vlanid <vidlist>] [disable | enable]
The config lldp ports dot1 TLVs command defines lldp admin status per port
on the switch.
[<portlist> | all] – Specify a port or ports to be configured.
vlan <vlan_name 32> –The name of the VLAN to be configured.
dot1_tlv_vlan_name − Defines if the advertisement is enabled or disabled.
vlanid <vidlist> –The vid of the VLAN to be configured.
Only Administrator or operator-level users can issue this command.
282