Lldp Commands; Enable Lldp - D-Link DES-1210-28/ME Reference Manual

The LLDP commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command

enable lldp

disable lldp
config lldp
message_tx_interval
config lldp
message_tx_hold_multiplier
config lldp reinit_delay
config lldp tx_delay
show lldp
show lldp ports
show lldp local_ports
show lldp remote_ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports ports
config lldp ports ports
config lldp ports ports
config lldp ports ports
show lldp mgt_addr
show lldp statistics
Each command is listed in detail, as follows:
enable lldp
Purpose
Syntax
DES-1210-28/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameter
<sec 5-32768>
<int 2-10>
<sec 1-10>
<sec 1-8192>
{<portlist>}
{<portlist>} {mode[brief | normal | detailed]}
{<portlist>} {mode[brief | normal | detailed]}
[<portlist> | all] notification [enable | disable]
[<portlist> | all] admin_status [tx_only | rx_only | tx_and_rx | disable]
[<portlist>|all] mgt_addr ipv4 <ipaddr> [enable | disable]
[<portlist>|all] basic_tlvs [all | {port_description | system_name |
system_description | system_capabilities}] [enable | disable]
[<portlist>|all] dot3_tlvs [all | link aggregation | mac_phy_configuration_status
| maximum_frame_size | power_via_mdi] [enable | disable]
[<portlist>|all] dot1_tlv_pvid [disable | enable]
[<portlist>|all] dot1_tlv_protocol_identity [all | eapol | gvrp | lacp | stp][disable
| enable]
[<portlist>|all] dot1_tlv_vlan_name [vlan <vlan_name 32> | vlanid <vidlist>]
[disable | enable]
{ipv4 <ipaddr>}
{ports <portlist>}
To enable LLDP on the switch.
enable lldp

LLDP COMMANDS

273
42 42 42 42