Network Menu - Oki C5400n User Manual

NETWORK MENU

This menu controls the operation of the printer's 10Base-T/100Base-
TX network interface.
NETWORK MENU
Item
TCP/IP
NETBEUI
NETWARE
ETHERTALK
FRAME TYPE
IP ADDRESS SET
IP ADDRESS
SUBNET MASK
GATEWAY ADDRESS xxx.xxx.xxx.xxx
INITIALIZE NIC?
WEB/IPP
TELNET
FTP
SNMP
LAN
HUB LINK SETTING AUTO NEGOTIATE
Settings
ENABLE / DISABLE Enables or disables this network protocol.
ENABLE / DISABLE Enables or disables this network protocol.
ENABLE / DISABLE Enables or disables this network protocol.
ENABLE / DISABLE Enables or disables this network protocol.
AUTO / 802.2 /
802.3 / ETHERNET
II / SNAP
AUTO / MANUAL
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
EXECUTE
ENABLE / DISABLE Enables or disables Web config. facility and
ENABLE / DISABLE Enables or disables Telnet config. facility.
ENABLE / DISABLE Enables or disables communication via FTP.
ENABLE / DISABLE Enables or disables SNMP protocol.
NORMAL / SMALL
100BASE-TX FULL
100BASE-TX HALF
10BASE-T FULL
10BASE-T HALF
MENU FUNCTIONS > 83
Explanation
Selects the Ethernet MAC layer frame type.
Specifies whether IP address allocation is
automatic (DHCP) or manually assigned.
Current assigned IP address. To change,
press ENTER and use +/– keys to increment
1st octet, then press ENTER again to move
on to next octet. When 4th octet has been
set, press ENTER again to register new
address.
Current assigned subnet mask. To change,
proceed as above.
Current assigned gateway address. To
change, proceed as above.
Initialises the network hardware.
Internet Printing Protocol.
Selects network size.
Sets full or half duplex for communication
via a network hub.