Table of Contents
Advertisement
FUSER REPLACEMENT
The fuser is located inside the printer just behind the four image drum
units.
If the printer has recently been powered on, some fuser components
will be very hot. Handle the fuser with extreme care, holding it only by
its handle, which will only be mildly warm to the touch. A warning
label clearly indicates the area. If in doubt, switch the printer off and
wait at least 10 minutes for the fuser to cool before opening the printer
cover.
Switch off the printer and allow the fuser to cool for about 10 minutes
before opening the cover.
1.
Press the cover release and open the printer's top cover fully.
WARNING!
REPLACING CONSUMABLE ITEMS > 113
Advertisement
Table of Contents
