Table of Contents
Advertisement
7.
Lower the new belt unit into place, with the lifting bar at the
front and the drive gear towards the rear of the printer. Locate
the drive gear into the gear inside the printer by the rear left
corner of the unit, and lower the belt unit flat inside the
printer.
8.
Turn the two fasteners (5) 90° to the right until they lock. This
will secure the belt unit in place.
9.
Replace the four image drums, complete with their toner
cartridges, into the printer in the same sequence as they came
out: cyan (nearest the rear), magenta, yellow and black
(nearest the front).
10.
Finally, close the top cover and press down firmly at both
sides so that the cover latches closed.
REPLACING CONSUMABLE ITEMS > 112
Advertisement
Table of Contents
