Table of Contents
Advertisement
N
ETWORK MENU
This menu controls the operation of the printer's 10Base-T/100Base-TX network interface.
ITEM
TCP/IP
IP VERSION
NETBEUI
NETBIOS OVER TCP
NETWARE
ETHERTALK
FRAMETYPE
IP ADDRESS SET
IP ADDRESS
SUBNET MASK
GATEWAY ADDRESS
WEB
TELNET
FTP
IPSEC
SNMP
NETWORK SCALE
DEFAULT
ENABLE
IP v4
DISABLE
ENABLE
DISABLE
DISABLE
AUTO
AUTO
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
ENABLE
DISABLE
DISABLE
DISABLE
ENABLE
NORMAL
Menu functions > 25
REMARKS
Enables or disables this network protocol.
Sets up the IP version.
Operates with IP v4 only (not valid with IPv6).
Operates with both IP v4 and IPv6.
Operates with IPv6 only (not valid with IPv4).
From this stage, if IPv6 only is set from UI, for
example Telnet, "IP v6" appears as the value of IP
Version on the operation panel. "IP v6" will disappear
from the value if "IP v4" or "IP v4+v6" is selected.
Display Condition: TCP/IP should be enabled.
Enables or disables this network protocol.
Sets Enable/Disable of NetBIOS over TCP protocol.
Display Conditions:
>
TCP/IP should be enabled.
>
IP Version is not IPv6.
Enables or disables this network protocol.
Enables or disables this network protocol.
Selects the Ethernet MAC layer frame type.
Display Condition: Netware should be enabled.
Specifies whether IP address allocation is automatic
(DHCP) or manually assigned.
Current assigned IP address. To change, press ENTER
and use Menu buttons to increment 1st octet, then
press ENTER again to move on to next octet. When 4th
octet has been set, press ENTER again to register new
address.
Current assigned subnet mask. To change, proceed as
above.
Current assigned gateway address. To change,
proceed as above.
Enables or disables Web config. facility.
Enables or disables Telnet config. facility.
Enables or disables communication via FTP.
Sets Enable/Disable of IPSec. Enable via the web.
Enable: IPSec is available.
Disable: IPSec is not available.
Enables or disables SNMP protocol.
Selects network size.When NORMAL is selected,
printer can work effectively, even when connected to a
HUB that has a spanning tree feature. However, printer
start up time gets longer when computers are
connected with two or three small LANs.When SMALL
is selected, computers can cover from two or three
small LANs to a large LAN, but may not work
effectively when connected to a HUB that has a
spanning tree feature.
Advertisement
Table of Contents
