Recording Images And Audio; Manual Recording Of Images And Audio; Recording Mode And Priority; Audio Recording - Panasonic WJ-ND400 Operating Instructions Manual

Recording images and audio

Recording and playing images
Manual recording of images and
audio
You can set the recorder for manual recording of images and audio.
Check with your system administrator about the manual recording
settings.
1
Click the [HDD] tab.
2
Click the [Up] button in the [Rec] box.
Click the [Up] button until the [Recording] and [Recording
stop] button are displayed.
3
Click the [Recording] button.
The [REC] indicator in the status display area lights (red),
and recording starts.
4
Click the [Recording stop] button.
The [REC] indicator in the status display area turns off, and
recording stops.
Note:
• When recording in a recording mode that has a higher priority
than Manual, Manual recording goes to standby until the other
recording finishes. Refer to the "Recording mode and priority"
(table) for information about access priority.
• When recording in modes other than Manual recording
(Emergency recording, Event recording, or Schedule
recording), recording continues even if you press the
[Recording stop] button.
• It is impossible to record images when images are not being
received from cameras.
18

Recording mode and priority

The recorder has 5 recording modes. The access priority of the
recording modes is shown below. Images are recorded in the
highest priority mode when two or more recordings with different
recording modes started simultaneously, only recording with the
highest priority will start.
Priority Recording mode
1 Emergency recording
2 Post-event recording
3 Manual recording
4 Schedule recording
5 Pre-event recording

Audio recording

Audio can be recorded together with images. Audio recording can be
set for each of the camera channels. Refer to the Setup Instructions
(PDF file) for more information.
Note:
• Audio recording without images cannot be done. Only image
can be recorded.
• Audio recording and SD memory recording cannot be done at
the same time. When recording rate of the SD memory
recording is set to other than [Off], audio recording for that
camera channel is automatically turned [Off].