Site Alarm - Panasonic WJ-ND400 Operating Instructions Manual

Event

Site alarm

Use the following procedure to configure settings that control terminal alarm action when a Panasonic alarm protocol alarm (site alarm) is sent
from a camera.
1
Click the [Event] button on the setup menu.
2
On the sub-menu that appears, click [Site alarm].
This will display the site alarm setting window.
Site alarm settings
Item
Site alarm
Port number
(from camera to ND400)
Site alarm setup
Rec. cam.
Preset position
Output terminal
♦Initial default
40
Settings
Off♦ / On
Port number input
(1818♦)
Cam.1 to Cam.64 / --
Signal input
(Blank♦)
Off / On♦
3
Configure the settings for each item.
Refer to "Site alarm settings" table for details about the
settings.
• To configure the settings of a camera that is not shown on
the display, click the applicable camera number range
above the [Set] button to change the contents of the
display.
• Clicking a camera number range saves the currently
displayed camera settings.
4
Click the [Set] button.
Description
Specifies whether to validate the site alarm.
Specifies the port number that receives the site alarm.
Specifies the channel of the recording camera.
Specifies the preset position (1 to 256) during alarm input.
• When this setting is blank, the camera does not move to a
preset position.
Specifies whether an alarm signal should be output when an
event occurs.