Stacker Assy / Stacker Cover; Housing Upper Assy - Epson L800 Service Manual

L800/L801

1.3.3 Stacker Assy / Stacker Cover

Removal procedure
1. Open the Stacker Cover.
2. Remove the Stacker Assy.
3. Release the Stacker Cover from the two shafts and remove the Stacker Cover.
Shaft
Stacker Assy
Figure 1-18. Removing the Stacker Assy / Stacker Cover
When installing the Stacker Assy, insert the guide pins of the
Stacker Assy into the lower grooves of the Guide Stacker Assy.
(The upper grooves are used when CDR is printed.)
Groove
Guide Pin
Figure 1-19. Installing the Stacker Assy
Disassembly/Reassembly
Shaft
Stacker Cover
Groove
Guide Pin
Stacker Assy / Stacker Cover

1.3.4 Housing Upper Assy

Removal procedure
1. Remove the four screws and remove the Upper Housing upward.
Screw : C.B.P. M3x10 (tightening torque: 5-7 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.)
[Rear Side]
4
1
Groove
Figure 1-20. Removing the Upper Housing
3
2
Upper Housing
Groove
Confidential
Revision A
25