Memory Function Of The Remote Control Key - Skoda Superb Owner's Manual

Retrieving the saved setting
Ignition Driver's door
Open
Switched off
Closed
Open
Activated
Closed
Stopping the ongoing adjustment
›
Press any button on the driver's seat or the button
key.
Note
Each time you save the seat- and exterior mirror settings for forward travel
you also have to re-save the setting of the exterior mirror on the passenger
side for reversing.

Memory function of the remote control key


Read and observe on page 80 first.
The automatic storage of the driver's seat and exterior mirror positions when
locking the vehicle can be turned on in the memory of the remote control key
(afterwards only as function of automatic storage).
This function can also be activated or deactivated in the Infotainment
k obsluze infotainmentu, chapter CAR - Vehicle Settings.
Activate the function of automatic storage
›
Unlock the vehicle with the remote control key.
›
Press and hold any memory button
›
After the seat has assumed the position stored under this button, at the
same time press the button

The successful activation of the automatic storage function for each key is
confirmed by an acoustic signal.
Storing driver's seat and exterior mirror settings for driving forward
›
Enable automatic storage.
When automatic storage is activated, the current positions of the driver's seat
and the external mirrors are saved in the memory of the remote control key
each time the vehicle is locked.
82
Using the system
Press the required memory button
» Fig. 71
Short
Long
Long
Long
on the remote control

» Fig. 71 on page 81.
B
on the remote control key within 10 seconds.
When the vehicle is next unlocked using the same key, the driver's seat and
the external mirrors assume the positions stored in the memory of this key.
B
Saving front passenger mirror settings when reversing
The function of lowering the passenger mirror surface when reversing must be
enabled in Infotainment
cle Settings .
›
Unlock the vehicle with the relevant remote control key.
›
Switch-on the ignition.
›
Turn the knob for the external mirror control to the position for the passen-
ger side mirror adjustment
›
Engage reverse gear.
›
Adjust the front passenger's mirror to the desired position.
›
Disengage reverse gear.
The adjusted position of the exterior mirror is stored in the remote control key
memory.
Disable function of automatic storage
›
Unlock the vehicle with the remote control key.
›
Press the  button (Position
›
Press the button
The successful deactivation of the automatic storage function for each key is
confirmed by an acoustic signal.
Stop the ongoing adjustment
›
» návod
Press any button on the driver's seat or the button
key.
» návod k obsluze infotainmentu, chapter CAR - Vehi-
» page 78.
» Fig. 71 on page 81) and hold.
A
on the remote control key within 10 seconds.

on the remote control
