Skoda Superb Owner's Manual page 139

Upon activation, in the instrument cluster the indicator turns
shows the following message.
Traction control (TCS) activated.

ASR ON

The TCS should normally always be enabled. The system should be deactivated
only in the following situations, for example.
›
When driving with snow chains.
›
When driving in deep snow or on a very loose surface.
›
When it is necessary to "rock" a car free when it has become stuck.
Electronic differential lock (EDL and XDS)

Read and observe on page 134 first.
EDL
EDL prevents the turning of the respective wheel of the driven axle. EDL
brakes the spinning wheel, if necessary, and transmits the driving force to the
other driving wheel. Driving becomes easier on road surfaces with different
traction under each wheel of the driven axle.
EDL switches off automatically to avoid excessive heat generation on the
brake of the wheel being braked. Once the brakes have cooled down, there is
an automatic re-activation of EDL.
XDS
XDL is an extension to the electronic differential lock. XDL does not respond to
traction, but to the load relief of the inner front wheel of the driving axle dur-
ing fast cornering.
The automatic brake intervention on the brake of the wheel with reduced load
prevents the wheel from spinning. Thus, the traction is improved and the vehi-
cle can continue to follow the desired track.
Driver Steering Recommendation (DSR)

Read and observe on page 134 first.
In critical situations, the DSR provides the driver with a steering recommenda-
tion in order to stabilise the vehicle. The DSR is activated, for example, on the
right and left vehicle side when braking sharply on different road surfaces.
136
Driving
and the display

Brake Assist (HBA)

Read and observe
The HBA increases the braking effect and helps to reduce the braking dis-
tance.
The HBA is activated by very quick operation of the brake pedal. In order to
achieve the shortest possible braking distance, the brake pedal must be ap-
plied firmly until the vehicle has come to a standstill.
The HBA function is automatically deactivated when the brake pedal is re-
leased.
Hill Start Assist (HHC)

Read and observe
When driving on slopes, HHC allows you to move your foot from the brake ped-
al to the accelerator pedal without the vehicle rolling downhill on its own.
The system holds the brake pressure produced by the activation of the brake
pedal for approx. 2 seconds after the brake pedal is released.
The HHC is active from a 5% slope if the driver's door is closed. HHC is only ev-
er active on slopes when in forward or reverse start off.
Multi collision brake (MCB)

Read and observe
The MCB helps to decrease speed after a collision through automatic braking
interventions and to stabilize the vehicle. This reduces the risk of a subse-
quent crash due to uncontrolled vehicle movement.
The automatic brake interventions can take place only if the following condi-
tions are met.
There was a front, side and rear-end collision of a certain severity.

The impact speed was higher than approx. 10 km/h.

The brakes, the ESL and other required electrical systems remain function-

al after impact.
The accelerator pedal is not actuated.

on page 134 first.
on page 134 first.
on page 134 first.