Traffic Sign Recognition - Skoda Superb Owner's Manual

For this reason, the chapters on System Lane Assist and ACC are to be read
carefully and the safety notes are to be observed.
System intervention
If the system detects the driver's inactivity, it draws attention to this fact by a
beep and a message on the display of the instrument cluster. It keeps the ve-
hicle in its lane.
If the driver does not take over the steering even after repeated warning, the
system begins to automatically brake the vehicle. After the vehicle has come
to a stop, automatic activation of the parking brake takes place.
With automatic braking, the hazard warning lights are activated to warn other
road users.
Note
The automatic braking interventions can be cancelled by pressing the acceler-
ator pedal or by steering intervention.
Operating conditions

Read and observe on page 171 first.
The system can intervene when the following basic conditions are present.
Lane Assist is activated and the boundary line is detected at least on one

side of the lane » page 166.
ACC is activated and the regulation

The vehicle speed is no more than about 65 km/h.


Traffic sign recognition


Introduction
This chapter contains information on the following subjects:
Function
Additional display
Information messages
The traffic sign recognition (hereinafter referred to only as system) shows cer-
tain traffic signs (e.g. speed limits) on the display of the instrument cluster and
if necessary warns against excessive speeds.
172
Driving
» page 154 follows.
WARNING
The system only serves to support and does not relieve the driver of the
■
responsibility for the vehicle operation.
Vertical traffic signs must always take precedence over the traffic signs
■
shown in the display. The driver is always responsible for correctly assess-
ing the traffic situation.
Traffic signs may not be recognised at all by the system, or may be recog-
■
nised incorrectly. As a result, the traffic signs may not be displayed at all, or
the wrong one may appear.
The speed information in the displayed traffic signs relate to the custom-
■
ary speed units in that land. For example, the display  may therefore refer
in specific countries km / h or mph.
Note
The system is only available in some countries.
Function
172
173
173
Fig. 199
Camera viewing range for traffic
sign recognition
