Read and observe
on page 219 first.
The starting process using the battery of another vehicle requires the use of
jumper cables.
The jump-start cables must be attached in the following sequence.
›
Attach clamp
to the positive terminal of the discharged battery
1
» Fig. 230
.
›
Attach clamp
to the positive terminal of the battery supplying power
2
›
Attach clamp
to the negative terminal of the battery supplying power
3
›
Attach the clamp
to a solid metal part which is connected firmly to the en-
4
gine block or to the engine block itself.
The jump-start cable must be connected to the engine earthing point only on
vehicles with the START-STOP system
Starting engine
›
Start the engine on the vehicle providing the power and allow it to idle.
›
Start the engine of the vehicle with the discharged battery.
›
If the engine does not start, terminate the attempt to start the engine after
10 seconds and wait for 30 seconds before repeating the process.
›
Remove the jump start cables in the reverse order as attachment.
Both batteries must have a rated voltage of 12 V. The capacity (Ah) of the bat-
tery supplying the power must not be significantly less than the capacity of
the discharged battery in your vehicle.
Jump-start cables
Only use jump-start cables which have an adequately large cross-section and
insulated terminal clamps. Observe the instructions of the jumper lead manu-
facturer.
Positive cable - colour coding in the majority of cases is red.
Negative cable - colour coding in the majority of cases is black.
220
Do-it-yourself
Fig. 231
Engine earth: START-STOP sys-
tem
A
» Fig.
231.
WARNING
Do not clamp the jump-start cable to the negative terminal of the dis-
■
charged battery. There is the risk of detonating gas seeping out the battery
being ignited by the strong spark which results from the engine being star-
ted.
The non-insulated parts of the terminal clamps must never touch each
■
other – risk of short circuit!
The jump-start cable connected to the positive terminal of the battery
■
must not come into contact with electrically conducting parts of the vehicle
– risk of short circuit!
Route the jump-start cables so that they cannot be caught by any rotat-
■
ing parts in the engine compartment.
Towing the vehicle
Introduction
.
B
.
B
Fig. 232 Braided tow rope / Spiral tow rope
This chapter contains information on the following subjects:
Front towing eye
Rear towing eye
Vehicles with a tow hitch
For towing, a braided tow rope is to be used
When towing, the following guidelines must be observed.
Vehicles with manual transmission may be towed in with a tow bar or a tow
rope or with the front or rear wheels raised.
221
222
222
» Fig. 232
- .