›
Insert the lamp with the holes
›
Carefully press the light into the studs on the bodywork.
Ensure that the wiring harness does not become pinched between the body
and the lamp.
›
Screw the tail lamp into place and install the cover.
The cover must engage securely.
If you are not sure whether the wiring harness has become pinched, we rec-
ommend that you have the light connection checked by a specialist garage.
CAUTION
Ensure that the wiring harness does not become pinched between the body
■
and the lamp when it is being refitted – risk of damage to the electrical instal-
lation and risk of water ingress.
Ensure that the vehicle paintwork and the tail lamp are not damaged when
■
removing and installing the lamp.
Make sure that when refitting the seal
■
ted correctly. Water and dirt may get into the lamp if the cover is not replaced
properly - there is a risk of damage to the lamp!
Replacing bulbs in rear light
Fig. 258 Tail light / bulb replacement
Read and observe
and
›
Turn the holder with the bulb
A
.
1
›
Remove the socket with the bulb from the lamp housing in the direction of
arrow
.
2
onto the studs
in the body.
D
C
» Fig. 258
on page 235 it is inser-
C
on page 231 first.
or
» Fig. 258
in the direction of the arrow
B
›
Push the faulty bulb into the holder, turn in anti -clockwise direction up to
the stop and remove.
›
Insert a new bulb into the holder and turn in a clockwise direction to the
stop.
›
Reinsert the holder with the bulb into the lamp housing and turn in the op-
posite direction of the arrow
1
to the stop.
Fuses and light bulbs
235