Adaptive Cruise Control (Acc) - Skoda Superb Owner's Manual

Operation description

Read and observe on page 153 first.
Overview of the control elements of the Speed Limiter
Speed Limiter disable (set limit delete)
A

Interrupt control (sprung position)

Activate GRA (required condition for the subsequent activation of

the speed limiter)
To activate the speed limiter the switch is to be adjusted to posi-
tion , then press
D
Take control again / Increase speed - short press (in increments
B a)

of 1 km/h), long press (in increments of 10 km/h)
Start regulation / reduce speed - short press (in increments of 1
C

km/h), long press (in increments of 10 km/h)
Switch between GRA
D

a)
If no speed limit is set, the current speed is set as the speed limit.
At the start of the regulation, the current speed is set as the speed limit and
displayed in the instrument cluster display. The warning light
the instrument cluster.
Exceeding the speed limit during the regulation
If exceeding the speed limit is required during the regulation, for example
when overtaking, then the accelerator pedal is to be fully pressed.
When exceeding the speed limit, an acoustic signal sounds and the warning
light in the instrument cluster flashes.
The regulation is resumed once the speed has fallen below the set limit.
154
Driving
Fig. 182
Operating elements of the speed
limiter
» Fig. 182
to operate.
» page 151 and Speed Limiter
illuminates in

CAUTION
When driving downhill, exceeding the set speed limit may occur. When exceed-
ing the limit, an acoustic signal sounds and the warning light in the instru-
ment cluster flashes.
Note
By pressing the button » Fig. 182
D
the GRA is activated.

Adaptive Cruise Control (ACC)


Introduction
This chapter contains information on the following subjects:
Radar sensor
Operation
Automatic stop-start
Operation Overview
Start control
Stop/resume control
Set/change the desired speed
Set the clearance level
Special driving conditions
Information messages
The automatic distance control (hereinafter referred to only as ACC) maintains
the set speed or the distance to the vehicle ahead without the accelerator or
brake pedal being pressed.
The state in which the ACC maintains the speed or the proximity is described
as control from here on.
WARNING
The ACC only serves to support and does not relieve the driver of the re-
■
sponsibility for the vehicle operation.
The driver must always be ready to take over steering of the vehicle him-
■
self (accelerate or brake).
Always adapt your speed and safety proximity to the vehicle ahead to the
■
current visibility, weather, road and traffic conditions.
during the regulation this is cancelled and
155
156
156
157
157
158
158
158
159
160
