(1) Removing the separators
WARNING
The separators are extremely hot immediately after the printer was running. Allow
substantial period of time until it cools down.
1. Remove and split the fuser unit. See page 5-29.
2. Remove the upper exit guide 1 while unlatching three latches 2.
3. Remove the exit pulley 3.
4. Hold the separator 4 upright and remove the separator 4 and the separator spring 5.
Step 1
4
FS-1900
2
2
Step 2
4
Figure 5-2-29 Removing the separators
5
5-32
1
3
2