NETGEAR ProSAFE M5300 Series Software Administration Manual page 562
Managed switches
Hide thumbs
Also See for ProSAFE M5300 Series:
- Hardware installation manual (32 pages) ,
- Installation manual (2 pages) ,
- User manual (764 pages)
Table of Contents
Advertisement
A screen similar to the following displays.
b. In the Tunnel ID list, select 0.
c. In the Mode field, select 6-in-4-configured.
d. In the Source Address field, enter 192.168.1.1.
e. In the IPv6 Mode field, select Enable.
f. In the IPv6 Address/Prefix Length field, enter 2000::1/64.
g. In the Destination Address field, enter 192.168.1.2.
h. Click Apply.
Web Interface: Create a 6in4 Tunnel on Switch 2
1.
Enable IP routing on the switch.
a. Select Routing > IP > Basic > IP Configuration.
A screen similar to the following displays.
b. For Routing Mode, select the Enable radio button.
c. Click Apply.
2.
Enable IPv6 forwarding and unicast routing on the switch.
a. Select Routing > IPv6 > Basic > Global Configuration.
Managed Switches
Tunnels for IPv6
562
Advertisement
Table of Contents
