Nssa Areas; Cli: Configure Area 1 As An Nssa Area - NETGEAR ProSAFE M5300 Series Software Administration Manual

c. Click Apply to save the settings.
5. Configure area 0.0.0.1 as a stub area.
a. Select Routing > OSPF > Advanced > Stub Area Configuration.
A screen similar to the following displays.
b. In the Area ID field, enter 0.0.0.1.
c. Click Add to save the settings.

NSSA Areas

Port 2/0/11
Area 0
Figure 16. NSSA area
The example is shown as CLI commands and as a web interface procedure.

CLI: Configure Area 1 as an NSSA Area

1. Enable routing on the switch.
(Netgear Switch) #config
(Netgear Switch) (Config)#router ospf
(Netgear Switch) (Config)#ip routing
Managed Switches
Layer 3
switch
Port 2/0/19
Area 1
OSPF
155
Layer 3
Switch
Port 1/0/15