Web Interface: Configure Ospfv3 - NETGEAR ProSAFE M5300 Series Software Administration Manual
Managed switches
Hide thumbs
Also See for ProSAFE M5300 Series:
- Hardware installation manual (32 pages) ,
- Installation manual (2 pages) ,
- User manual (764 pages)
Table of Contents
Advertisement
Web Interface: Configure OSPFv3
1.
Enable IPv6 unicast routing on the switch.
a.
Select Routing > IPv6 > Basic > IPv6 Global Configuration.
A screen similar to the following displays.
b. For IPv6 Unicast Routing Mode, select the Enable radio button.
c.
Click Apply to save the settings.
2.
Specify the router ID, and enable OSPFv3 for the switch.
a. Select Routing > OSPFv3 > Basic > OSPFv3 Configuration.
A screen similar to the following displays.
b. Under the OSPF Configuration, enter the following information:
•
In the Router ID field, enter 1.1.1.1.
•
For Admin Mode, select the Enable radio button.
c.
Click Apply to save the settings.
3.
Enable IPv6 on port 1/0/1.
Managed Switches
OSPF
174
Advertisement
Table of Contents
