Web Interface: Enable Dhcp L2 Relay - NETGEAR ProSAFE M5300 Series Software Administration Manual
Managed switches
Hide thumbs
Also See for ProSAFE M5300 Series:
- Hardware installation manual (32 pages) ,
- Installation manual (2 pages) ,
- User manual (764 pages)
Table of Contents
Advertisement
Web Interface: Enable DHCP L2 Relay
1.
Create VLAN 200.
a. Select Switching > VLAN > Basic > VLAN Configuration.
A screen similar to the following displays.
b. In the VLAN ID field, enter 200.
c. In the VLAN Type field, select Static.
d. Click Add.
2.
Add ports to VLAN 200.
a. Select Switching > VLAN > Advanced > VLAN Membership.
A screen similar to the following displays.
b. In the VLAN ID field, select 200.
c. Click Unit 1. The ports display.
d. Click the gray boxes under ports 4, 5, and 6 until U displays.
The U specifies that the egress packet is untagged for the port.
e. Click Apply.
3.
Specify the PVID on ports 1/0/4, 1/0/5 and 1/0/6.
a. Select Switching > VLAN > Advanced > Port PVID Configuration.
Managed Switches
DHCP L2 Relay and L3 Relay
647
Advertisement
Table of Contents
