Cli: Configure Area 1 As An Nssa Area On A2 - NETGEAR ProSAFE M5300 Series Software Administration Manual
Managed switches
Hide thumbs
Also See for ProSAFE M5300 Series:
- Hardware installation manual (32 pages) ,
- Installation manual (2 pages) ,
- User manual (764 pages)
Table of Contents
Advertisement
c. Enter the following information:
•
In the OSPF Area ID field, enter 0.0.0.1.
•
In the OSPF Admin Mode field, select Enable.
d. Click Apply to save the settings.
7.
Configure area 0.0.0.1 as an NSSA area.
a. Select Routing > OSPF > Advanced > NSSA Area Configuration.
A screen similar to the following displays.
b. Enter the following information.
•
In the Area ID field, enter 0.0.0.1.
•
In the Import Summary LSA's field, select Disable.
c. Click Add to save the settings.
CLI: Configure Area 1 as an NSSA Area on A2
1.
Enable routing on the switch.
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#router ospf
2.
Set the router ID to 2.2.2.2.
(Netgear Switch) (Config-router)#router-id 2.2.2.2
3.
Configure the area 0.0.0.1 as an NSSA area.
(Netgear Switch) (Config-router)# area 0.0.0.1 nssa
Managed Switches
OSPF
160
Advertisement
Table of Contents
