Web Interface: Enable Routing For The Switch; Enable Routing For Ports On The Switch - NETGEAR ProSAFE M5300 Series Software Administration Manual
Managed switches
Hide thumbs
Also See for ProSAFE M5300 Series:
- Hardware installation manual (32 pages) ,
- Installation manual (2 pages) ,
- User manual (764 pages)
Table of Contents
Advertisement
Web Interface: Enable Routing for the Switch
1.
Select Routing > IP > Basic > IP Configuration.
A screen similar to the following displays.
2.
For Routing Mode, select the Enable radio button.
3.
Click Apply to save the settings.
Enable Routing for Ports on the Switch
Use the following commands or the web interface to enable routing for ports on the switch.
The default link-level encapsulation format is Ethernet. Configure the IP addresses and
subnet masks for the ports. Network-directed broadcast frames will be dropped. The
maximum transmission unit (MTU) size is 1500 bytes.
Managed Switches
Port Routing
105
Advertisement
Table of Contents
