Configure Auto Install Through The Cli - NETGEAR M6100 Series Software Setup Manual

The configuration file is located on the TFTP server (for example, switch.cfg).
192.168.0.1
DHCP
server
Figure 1. Components in an Auto Install configuration

Configure Auto Install Through the CLI

This section describes how to configure Auto Install through the CLI.
To use the CLI to configure Auto Install:

1. Download the configuration file from the TFTP server.
2. Save the configuration file automatically after autoconfig completes.
(Netgear switch) #boot host auto-save
3. Continue Auto Install:
(Netgear switch) #boot autoinstall start
4. Request an IP address, configuration file name, and TFTP IP address from the DHCP
server:
(Netgear switch) #
Config file 'startup-config' created successfully.
AutoInstalled configuration is saved.
(Netgear switch) #show autoinstall
AutoInstall Mode.............................. Stopped
AutoInstall Persistent Mode................... Enabled
AutoSave Mode................................. Disabled
AutoInstall Retry Count....................... 3
AutoInstall State............................. AutoInstall is completed.
Auto Install is now completed.
M6100, M5300, and M7100 Series Switches
192.168.0.3
Use the Auto Install Configuration
25
192.168.0.2
TFTP
server