VTech ErisTerminal VSP735 Administrator And Provisioning Manual page 29

DHCP is enabled by default, which means the VSP735 will get its IP address from the
network. When DHCP is disabled, you must enter a static IP address for the VSP735.
To set static IP for the VSP735:
1. From the Network setting menu, press
press SELECT.
If DHCP is disabled, the Set static IP menu appears. If DHCP is enabled, an error
message appears briefly before returning you to the Network setting menu.
2. On the Set static IP menu, enter the static IP address. Use the dial pad and the
Add dot
Set static IP
IP:
Subnet Mask:
Gateway:
Cancel
3. Press
enter characters. Press
4. Press
characters. Press
5. Press
To set the VLAN ID for the VSP735:
1. From the Network setting menu, press
press SELECT.
2. On the VLAN ID menu, press
Configuration Using the Phone Menus
You must be familiar with TCP/IP principles and protocols to configure static IP
settings.
soft key to enter characters. Press
0.0.0.0
0.0.0.0
0.0.0.0
Backspc Add dot Save

and enter the Subnet Mask. Use the dial pad and the
 
or

and enter the Gateway. Use the dial pad and the Add dot soft key to enter
 
or to advance to the next character.
.
Save
VSP735 Administrator and Provisioning Manual
 
to highlight Set static IP, and then
or
 
or to advance to the next character.
to advance to the next character.
 
to highlight VLAN ID, and then
or
 
or to enable or disable the WAN VLan.
29
Add dot soft key to
Back to Contents